Goods lift
For factories and warehouses
Built for pallets, trolleys and heavy loads. Wide doors. Hard-wearing cabin.
- Capacity1000 – 5000 kg
- Doors2 m, 4-panel centre opening
- CabinSteel, hard-wearing
- CertifiedEN 81 · DOSH
Goods lift · Supply & install
Goods lifts for factories and warehouses
1000 to 5000 kg. Built for pallets, trolleys and heavy loads. Installed and certified with DOSH.
Built for the work
Specified for your load, not from a catalogue.
A goods lift is only as good as the load it was designed for. We start with what you move, how you move it, and how often.
Where our goods lifts go
- Factories: raw material up, finished goods down
- Warehouses and logistics hubs with mezzanine floors
- Shopping centres and hotels: back-of-house service lifts
- Commercial buildings: loading bay to upper floors
- Car workshops and showrooms
Tell us at the site visit
- Heaviest load and its size on the pallet
- How it moves: trolley, pallet truck or forklift
- Trips per hour at the busiest time
- Floors served and door positions (front, rear, or both)
- Whether staff ride with the load
- Shaft, pit and headroom you have, or can build
What you get
A steel car with a hard-wearing floor and bump rails, wide doors sized for your pallets, slower speeds that suit heavy loads, and a control system that is simple for warehouse staff to use. We install, test, arrange the JKKP (DOSH) inspection and hand over the Certificate of Fitness. Then we maintain it.
Already have a goods lift?
We repair, modernise and maintain goods lifts of any brand. Doors, floors and controllers wear fastest in a factory. Modernisation gives an old goods lift another working life at a fraction of the cost of a new one.
Common questions
Goods lifts, answered.
What loads can a goods lift carry?
From 1000 to 5000 kg. Tell us the heaviest load, its size, and how it is moved: trolley, pallet truck or forklift. We specify the platform, floor and doors for it.
Can a forklift drive into the lift?
Only if the lift is built for it. A forklift and its load put a heavy point load on the floor and the sill. Tell us at the site visit and we design for it.
Can people ride in a goods lift?
A goods lift is designed and certified for goods, with an attendant where the design allows it. If staff need to ride with the load, tell us and we specify the right class of lift.
What space does a goods lift need?
A shaft, a pit and headroom above the top floor. The sizes depend on the capacity and the door width. We measure at the free site visit and give you the structural requirements.
Do goods lifts need a Certificate of Fitness?
Yes. Goods lifts are inspected by JKKP (DOSH) and need a valid Certificate of Fitness, the same as passenger lifts. We install, test, arrange the inspection and then maintain the lift.
Can you modernise or repair our existing goods lift?
Yes, any brand. Goods lifts in factories work hard and wear out doors, floors and controllers. We repair, modernise and maintain them.
Tell us what you need.
We confirm your free site visit by WhatsApp.